Composition and Standard Grades
Ferrotungsten is an iron tungsten master alloy used to introduce tungsten into steel and cast iron. Commercial grades contain 70 to 80 percent tungsten, with grades such as FeW80-A, FeW80-B and FeW80-C distinguished mainly by tighter control of phosphorus, sulfur and carbon. Chinese production is standardised under GB/T 3648, which sets chemical limits, size ranges and sampling rules. Because tungsten has a very high melting point, the alloy is supplied in a coarse, dense form that is charged before or during melting rather than added at the end of the heat.
Production and Physical Characteristics
The alloy is made by reducing wolframite or scheelite concentrate with carbon or by an aluminothermic reaction, then casting and crushing the product. Ferrotungsten is hard, dense and brittle, with a density well above that of steel, so it tends to sink in the bath and needs sufficient superheat and stirring to dissolve. Density and lump size are therefore important commercial parameters, and buyers often specify a minimum piece size to avoid excessive fines that oxidise easily.
Why Tungsten Is Added to Steel
Tungsten forms very stable carbides and dissolves slowly, which gives steels excellent hot hardness and wear resistance. This is why ferrotungsten is a core alloy for high speed steel and hot work tool steel. In heat resistant and creep resistant grades, tungsten raises the softening temperature and improves resistance to tempering. In wear resistant cast irons it increases hardness and abrasion resistance. The strong carbide forming tendency also means tungsten improves cutting performance and dimensional stability of tools at elevated temperature.
Dissolution, Recovery and Addition Practice
Tungsten recovery depends on charge order, bath temperature and holding time. The usual approach is to add ferrotungsten early, before or with the scrap, so that it dissolves during the heat, and to avoid adding it to a cold bath. Aluminum or silicon can be used to protect the bath from excessive oxidation. Sampling for final tungsten content is normally done after full dissolution and stirring, because undissolved pieces cause low and erratic results. Oxidation losses rise sharply if the alloy is exposed to an oxidising slag.
Purchasing and Quality Checks
Key purchase parameters are tungsten content and consistency, phosphorus and sulfur limits, carbon level, piece size distribution and moisture. A supplier should provide a lot certificate with spectrometric analysis and a sieve report. Ferrotungsten should be stored dry and handled with care because fine material is dusty and can oxidise on long exposure. Comparing offers on contained tungsten rather than on gross weight gives the most reliable cost comparison between suppliers.
Frequently Asked Questions
Q: What is ferrotungsten used for?
It introduces tungsten into high speed steel, tool steel, heat resistant alloys and wear resistant cast iron.
Q: What is the typical tungsten content?
Most commercial grades contain 70 to 80 percent tungsten, with FeW80 grades being the most common.
Q: Which standard specifies ferrotungsten?
GB/T 3648 is the Chinese standard for ferrotungsten and defines grades, chemistry and sizes.
Q: When should ferrotungsten be charged?
It is charged early with the scrap so that it has time to dissolve at high temperature.
Q: Why does piece size matter?
Dense coarse pieces dissolve reliably, while excessive fines oxidise and reduce tungsten recovery.


