What Zirconium Foil Is and How It Is Made
Zirconium foil is a thin, flat product rolled from zirconium or zirconium alloy. Foil is commonly defined as material thinner than about 0.2 mm, and it is produced by hot rolling a slab, followed by cold rolling with intermediate annealing to control grain size, flatness and surface finish. Because zirconium has a hexagonal close packed structure, rolling schedules must be carefully designed to avoid cracking. Final properties depend on chemistry, annealing temperature and the amount of cold work left in the strip.
Grades and Specifications
The most common commercial grade is pure zirconium with controlled hafnium, usually supplied as Zr702. Nuclear applications use Zircaloy grades such as Zircaloy-2 and Zircaloy-4, which contain tin, iron, chromium and nickel additions to improve strength and corrosion behaviour. Chinese supply follows GB/T 21183 for zirconium and zirconium alloy sheet, strip and foil, while ASTM B551 or B551M is widely used internationally. A key point for buyers is the hafnium level, since hafnium has a high neutron absorption cross section and must be removed for nuclear grade material.
Corrosion Resistance and Physical Properties
Zirconium forms a thin, stable oxide film that protects it against many aggressive media, including most mineral acids, alkalis and salt solutions. It performs very well in hydrochloric and sulfuric acid service where stainless steel fails, but hydrofluoric acid and fluoride containing environments attack the protective film. Zirconium has a melting point around 1855 degrees Celsius, good ductility and a low thermal neutron absorption cross section in its hafnium free form. These properties explain its use in both chemical plant equipment and nuclear fuel assemblies.
Applications of Zirconium Foil
Foil and thin strip are used for heat exchanger linings, packing, gaskets, burst discs and corrosion resistant components in chemical processing. In the nuclear industry, zirconium alloy strip is fabricated into fuel cladding and structural components. Foil is also used as a getter in vacuum devices, as a component in specialty electronics and as an interlayer in some joining processes. Thin gauge material allows designers to line vessels and form complex shapes while keeping weight and material cost under control.
Buying, Inspection and Handling
Purchasing zirconium foil requires clear specification of grade, hafnium content, thickness and tolerance, width, temper, surface finish and mechanical properties. Inspection typically covers chemical analysis, dimensional measurement, visual surface check and, for nuclear grade, ultrasonic or radiographic examination. Foil should be stored flat and dry, protected from contact with fluorides and from abrasion. Clean handling is important because surface contamination can reduce the protective oxide film and lead to premature corrosion in service.
Frequently Asked Questions
Q: What thickness is considered zirconium foil?
Foil generally refers to zirconium strip thinner than about 0.2 mm, produced by cold rolling and annealing.
Q: Which ASTM standard covers zirconium foil?
ASTM B551 or B551M covers zirconium and zirconium alloy strip, sheet and plate; GB/T 21183 is the Chinese equivalent.
Q: Why is hafnium content important?
Hafnium absorbs neutrons strongly, so nuclear grades require very low hafnium while industrial grades allow higher levels.
Q: Where is zirconium foil used?
It is used in chemical process equipment, nuclear fuel components, vacuum getters and specialty electronics.
Q: What limits zirconium corrosion resistance?
Fluoride containing media attack the protective oxide film, so hydrofluoric acid service is not suitable.


