ZhenAn Ferro Silicon
1. Accurate weighing of ingredients
The silica and coke used to produce ferrosilicon should be strictly weighed. If the weighing is inaccurate, the furnace conditions will be difficult to control and scrap may even be produced. Therefore, you must be careful in batching work, and you must often check the accuracy of weighing tools. If problems are found, they should be adjusted or repaired in time.
Ferro Silicon 75
2. Add ingredients according to strict smelting order
The order of placement is also very important when producing ferrosilicon. The pile specific gravity of coke is about 0.5 to 0.6, the pile specific gravity of silica is about 1.5 to 1.6, and the pile specific gravity of steel scraps is 1.8 to 2.2. The specific gravity of raw material piles varies greatly. In order to mix the furnace charge evenly, the order of ingredients is coke, silica, and then steel chips. Using this batching method, the furnace materials can be mixed evenly after they descend from the material tube. Whether the charge is evenly mixed or not has a great influence on smelting. In order to mix the furnace materials evenly, only one batch of materials should be measured at a time, and each hopper should store no more than two batches of materials.
Ferro Sillion Alloy
3. Where can I buy high-quality ferrosilicon products?
If you do not have the ability to produce ferrosilicon products, then it is very important to find a reliable ferrosilicon manufacturer to supply. Which ferrosilicon manufacturer can supply high-quality ferrosilicon products? Zhenan Metallurgy has relatively complete production equipment. We have complete facilities, rich experience and look forward to cooperating with you.
