Jan 08, 2026 Leave a message

Ferrovanadium 40 vs 60: Weldability Comparison

What Ferrovanadium 40 and 60 Represent

Ferrovanadium is a master alloy used to add vanadium to steel, and the number in the grade name refers to the nominal vanadium content. A grade with around 40 percent vanadium is a lower concentration master alloy, while a grade with around 60 percent vanadium is a more concentrated product. Higher vanadium content means less alloy is needed per unit of vanadium added and less dilution of the bath. Both grades are used in microalloyed, high strength low alloy and tool steel production, and both dissolve in the ladle with appropriate temperature and stirring.

How Vanadium Behaves in Steel

Vanadium is a strong carbide and nitride former. During solidification and subsequent processing it forms vanadium carbonitride precipitates that pin grain boundaries and contribute precipitation strengthening. Vanadium also raises hardenability by slowing the transformation of austenite. These effects are useful in the parent steel because they increase strength at relatively low addition levels. The same effects, however, also act in the heat affected zone of a weld, where the thermal cycle is rapid and uncontrolled.

Hardenability and Heat Affected Zone Behaviour

The heat affected zone is heated close to melting and then cooled quickly by the surrounding cold metal. If the steel has high hardenability, this fast cooling produces hard, brittle microstructures that are prone to hydrogen assisted cracking. Because higher vanadium increases hardenability, a steel treated with a 60 percent grade can show a harder heat affected zone than the same steel treated with a 40 percent grade at equal final vanadium. Weldability therefore depends not only on the addition level but also on the carbon equivalent and the section thickness.

Precipitates, Toughness and Grain Growth

At the same time, vanadium carbonitride particles that remain undissolved can restrict austenite grain growth in the heat affected zone, which improves toughness. The balance between hardening and grain refinement depends on the vanadium and nitrogen levels, the peak temperature and the cooling rate. Fine, well dispersed precipitates are beneficial, while coarse or excessive precipitates can embrittle the zone. This is why the effect of a 40 or 60 percent grade must be assessed together with the nitrogen content and the welding procedure.

Practical Selection for Welded Structures

For welded structures, the usual approach is to keep vanadium at a level that delivers the required strength without pushing the heat affected zone hardness above the acceptable limit. Preheating, controlled heat input and suitable consumables help manage the cooling rate. Where high strength is essential and welding is unavoidable, a lower vanadium master alloy combined with careful procedure qualification may be preferred. The grade choice should be confirmed by welding procedure tests rather than by alloy content alone.

Frequently Asked Questions

Q: What is the difference between ferrovanadium 40 and 60?
They differ mainly in vanadium content, about 40 percent versus about 60 percent, so less alloy is needed for a given addition with the 60 grade.

Q: Does higher vanadium reduce weldability?
Higher vanadium raises hardenability, which can harden the heat affected zone and increase cracking risk if not controlled.

Q: Which standard covers ferrovanadium grades?
GB/T 4139 defines common ferrovanadium grades including FeV50, FeV60 and FeV80.

Q: How is weldability improved with vanadium microalloying?
By controlling vanadium and nitrogen levels, limiting carbon equivalent, preheating and managing weld heat input.

Q: Are vanadium carbonitride precipitates helpful or harmful?
Fine precipitates refine grains and raise strength; coarse or excessive ones can reduce toughness.

Send Inquiry

Home

Phone

E-mail

Inquiry