1. Grade Designations
Ferrovanadium is designated by its vanadium content. The most common grades are FeV40, FeV50, FeV60 and FeV80, where the number indicates the nominal vanadium percentage. FeV80 contains roughly 75-82 percent vanadium and is the standard grade for alloy steel production, while FeV40 and FeV50 are used where a leaner alloy is acceptable.
The controlling standard GB/T 4139 sets the vanadium content ranges and the maximum limits for carbon, silicon, aluminum, phosphorus and sulfur in each grade. Buyers should confirm the exact grade specification with the supplier before ordering.
2. Typical Composition Ranges
As a practical guide, the commonly traded grades can be summarized as follows: FeV40 with about 40 percent vanadium, FeV50 with about 50 percent, FeV60 with about 60 percent, and FeV80 with about 75-82 percent vanadium. The balance is mainly iron, with small amounts of silicon, aluminum, carbon, phosphorus and sulfur.
Impurity limits tighten as the vanadium content rises, because high-grade material is usually destined for critical steel applications where residuals must stay low.
3. Size Ranges
Ferrovanadium is supplied in lump, crushed and powder forms. Typical lump sizes are 10-50 mm and 10-80 mm for furnace and ladle additions, while foundry users often order 2-10 mm or powder below 1 mm for precise dosing.
The size range is agreed at order time and checked at delivery, since the dissolution behavior and the weighing accuracy both depend on consistent lump size. Fines content is limited by the contract to keep yield predictable.
4. Packaging Options
Standard export packaging includes 1 metric ton big bags on pallets, 250 kg steel drums, and smaller drums of 25-50 kg for foundry dosing. The packaging is chosen to protect the alloy from moisture and to suit the handling equipment at the destination.
Each package carries the grade, size range, heat number and net weight. A packing list and the inspection certificate are issued with the shipment, and the certificate records the chemical analysis of the lot.
5. Ordering and Inspection
When ordering ferrovanadium, the buyer specifies the grade, the size range, the packaging and the inspection basis. Sampling and chemical analysis are performed in accordance with the standard methods for ferroalloys, and the results are compared with the agreed grade limits.
Specify the exact grade and impurity limits at order time.
Agree the size range and maximum fines content.
Require a certificate of analysis with every lot.
Frequently Asked Questions
Q: What do FeV40, FeV50, FeV60 and FeV80 mean?
They designate ferovanadium grades with nominal vanadium contents of about 40, 50, 60 and 75-82 percent.
Q: Which standard applies to ferrovanadium?
GB/T 4139 defines the composition and inspection requirements for ferrovanadium grades.
Q: What size ranges are normally supplied?
Lumps of 10-50 mm or 10-80 mm, crushed fractions of 2-10 mm, and powder below 1 mm.
Q: How is ferrovanadium packed for export?
In 1 metric ton big bags, steel drums, or smaller drums, palletized and labeled by heat number.
Q: What documents accompany the shipment?
A packing list and a certificate of analysis recording the chemical composition of the lot.


