Feb 20, 2024 Leave a message

Molybdenum Sheet Production Process

Raw Material: The Molybdenum Billet

The production of molybdenum sheet starts from molybdenum powder, which is pressed into bars and sintered at high temperature to form dense billets. Sintering removes porosity and gives the billet sufficient strength for subsequent hot working. The purity of the starting powder, typically 99.9 percent or higher, determines the final quality of the sheet, since impurities concentrate during rolling.

Hot Rolling of the Billet

Molybdenum has a body-centered cubic crystal structure and a melting point of about 2623 degrees Celsius, but it becomes workable only above its ductile-to-brittle transition temperature. The billet is therefore heated to about 1100 to 1400 degrees Celsius and hot rolled in multiple passes to break down the cast or sintered structure. Each pass reduces thickness progressively while the temperature is maintained to avoid cracking.

Intermediate Rolling and Annealing

After the initial breakdown, the material is further rolled at lower temperatures, and intermediate annealing is applied to restore ductility between passes. Annealing removes work hardening and recrystallizes the grain structure so that the sheet can be reduced further without edge cracking. The number of rolling and annealing cycles depends on the final thickness target.

Finish Rolling and Surface Treatment

Thin molybdenum sheet and foil are produced by finish rolling on precision mills with controlled tension and surface finish. The surface is then cleaned by grinding, pickling or chemical polishing to remove oxide scale and rolling marks. For very thin foil, multiple pack rolling passes are used, and the final surface quality is critical for electronic and sputtering applications.

Delivery Conditions Depending on Thickness

The delivery condition of molybdenum sheet depends on thickness: thicker plates are supplied in the stress-relieved or annealed state after hot rolling, while thin sheets and foil are usually supplied in the cold-rolled, bright-annealed condition. Dimensional tolerances, flatness and surface finish are specified according to the thickness range. Standards such as ASTM B386 define the applicable requirements.

Quality Control and Applications

Quality control includes density measurement, chemical analysis, dimensional inspection and mechanical testing. Molybdenum sheet is used in high-temperature furnace furniture, heating elements, radiation shields, glass melting electrodes, semiconductor components and sputtering targets. The combination of high melting point, good thermal conductivity and low thermal expansion makes it irreplaceable in many high-temperature systems.

Frequently Asked Questions

Q: How is the molybdenum billet produced?
Molybdenum powder is pressed into bars and sintered at high temperature to form dense billets.

Q: Why must molybdenum be hot rolled?
Molybdenum is brittle below its ductile-to-brittle transition temperature, so it is heated to about 1100 to 1400 degrees Celsius for hot rolling.

Q: What is the purpose of annealing during rolling?
Annealing restores ductility and recrystallizes the grain structure between rolling passes.

Q: How is the delivery condition selected?
Thick plates are supplied stress-relieved or annealed, while thin sheets and foil are usually cold-rolled and bright-annealed.

Q: Which standard applies to molybdenum sheet?
ASTM B386 covers molybdenum and molybdenum alloy plate, sheet, strip and foil.

Q: How many rolling and annealing cycles are needed?
The number of cycles depends on the final thickness target: the thinner the sheet, the more roll and anneal steps are required to reduce thickness without edge cracking.

Send Inquiry

Home

Phone

E-mail

Inquiry