Mar 27, 2024 Leave a message

Silicon Briquette Uses in Steelmaking

Overview of Silicon Briquettes

Silicon briquettes are pressed blocks made from silicon-bearing fines, such as silicon metal fines, silicon slag or ferrosilicon dust, combined with an inorganic binder and compacted under high pressure. The result is a uniform, dust-free product that can be charged directly into furnaces and ladles without the losses caused by powder handling. Briquettes are an established way to recycle silicon fines and to supply silicon at a lower cost than lump alloys.

How Silicon Briquettes Are Made

The raw fines are screened, blended to a target silicon content, mixed with a binder and fed to a briquetting press that forms blocks of defined size and density. Green briquettes are cured or dried to develop handling strength, and the finished product is tested for silicon content, size, strength and moisture. Typical briquettes range from about 20 to 60 millimetres and carry a silicon content that can vary from around 40 to 70 percent depending on the feedstock.

Mechanism in Steelmaking

When silicon briquettes are added to molten steel, the silicon dissolves and reacts with dissolved oxygen to form silica, which floats into the slag, and this oxidation releases heat into the bath. The deoxidation product improves steel cleanliness, while the heat release raises the temperature of the metal. In ironmaking and foundry practice, silicon additions increase the carbon equivalent and improve the fluidity of molten iron, helping thin-walled castings fill completely.

Advantages in the Melt Shop

Briquettes charge cleanly, sink into the metal quickly and produce little dust, improving recovery compared with loose fines. They allow melt shops to use low-cost silicon-bearing by-products instead of expensive lump alloys, reducing the cost of deoxidation. The defined weight and composition also make additions easier to control, and the compact form reduces storage space and transport losses.

Selection and Quality Points

Buyers should confirm the silicon content, the type of binder, the size range, the crushing strength and the moisture level, because these determine recovery and performance. Binder quality matters in steelmaking because organic binders can introduce hydrogen, while inorganic binders keep the chemistry clean. The silicon content should be certified by analysis, and the briquettes should be strong enough to survive transport without crumbling.

Frequently Asked Questions

Q1: What are silicon briquettes made from?
A1: They are pressed from silicon-bearing fines such as silicon metal fines or silicon slag, with an inorganic binder to hold the block together.

Q2: How do silicon briquettes work in steelmaking?
A2: Silicon dissolves in the steel and deoxidises it, while the exothermic oxidation releases heat that raises the bath temperature.

Q3: Why do they improve molten iron fluidity?
A3: The silicon addition raises the carbon equivalent of the iron, which lowers viscosity and helps castings fill thin sections.

Q4: What advantages do briquettes have over powder?
A4: They are dust-free, sink into the metal quickly, give higher recovery and allow the use of low-cost fines without handling losses.

Q5: What silicon content is typical?
A5: Briquettes are usually supplied at 40 to 70 percent silicon depending on the feedstock, with the content certified by analysis.

Q6: What should buyers check before purchase?
A6: Silicon content, binder type, size range, strength and moisture, because these factors control recovery and steel chemistry.

Send Inquiry

Home

Phone

E-mail

Inquiry