Dec 28, 2023 Leave a message

Why Can A Small Amount Of Silicon Carbide Be Used In Smelting Ferrosilicon?

Ultra-Low Carbon Ferrosilicon

 

The "silicon carbide" referred to here is not a specific raw material, but the thermal insulation waste of the graphitization furnace when manufacturing graphite electrodes. It contains a large amount of silicon carbide, so it is customary to call this waste "silicon carbide". Its ingredients are as follows:

SiC25~40%; SiO220%; C25%; the rest is Al2O3 and CaO, etc. Why adding a small amount of "silicon carbide" during smelting can reduce power consumption.

ferro silicon magnesium

Low titanium (high purity) ferrosilicon

 

When smelting ferrosilicon, the reduction of silicon dioxide is a reaction that absorbs a large amount of heat energy. Therefore, the reaction must be carried out intensely at a very high temperature (about 1800 to 1900°C), thus consuming a large amount of electrical energy. When part of silicon carbide is added to the charge, it reacts with the steel scraps in the charge as follows in the furnace:

SiC+Fe= FeSi+C

This reaction is an endothermic reaction, and the heat absorbed and the reaction temperature are lower than those required for the reduction of silicon dioxide. Therefore, adding part of silicon carbide to the furnace charge can reduce power consumption.

 

 

Ferro Silicon 72

High-Silicon Ferrosilicon

In smelting 45 ferrosilicon, due to the large amount of steel scraps in the charge, the destruction reaction of silicon carbide is mainly carried out according to SiC + Fe = FeSi + C. Therefore, the utilization rate of silicon carbide is higher at this time.

Send Inquiry

Home

Phone

E-mail

Inquiry