1. If semi-automatic cutting is performed, the guide rail should be placed on the plane of the titanium tube, and then the cutting machine is placed on the guide rail. Note that the order cannot be reversed.
2. The cutting parameters must be appropriate and should be reasonably determined based on the thickness of the titanium tube, etc., in order to obtain good cutting results.
titanium square tube
3. Check whether the cutting nozzle air is unobstructed. If there is any blockage, clear it in time.
4. Before cutting, the surface should be cleaned and some space should be left to facilitate the blowing out of the slag.
titanium round tube
5. The distance between the cutting nozzle and the surface of the titanium tube should be appropriate. Too close or too far is not good.
6. Preheating should be sufficient to avoid affecting the cutting process.
7. If workpieces of different sizes are cut, small pieces should be cut first and then large pieces.
