Feb 18, 2024 Leave a message

Tips for improving surface toughness of titanium plates

Titanium alloy Plate

 

The final sintering temperature of titanium carbide high manganese steel bonded cemented carbide is generally 1420°C. The sintering temperature should not be too high. The bonding phase may even turn into a liquid phase and the metal may be lost, causing the hard phase to adjoin, aggregate and grow, forming a source of fragmentation. This is the reason why the bonding phase between the hard phase grains analyzed earlier becomes less. Of course, the sintering temperature cannot be too low, otherwise the alloy will be under-fired. In addition to controlling the sintering temperature and speed mentioned above, the vacuum degree in the furnace enters the liquid phase sintering stage. It is also necessary to control the degree of vacuum in the furnace during sintering, because too high a degree of vacuum will volatilize a large amount of liquid metal and cause component segregation. Especially in the three stages of degumming, reduction and liquid phase sintering, the heating rate during sintering should not be fast when sintering such alloys.

 

Titanium alloy Plate

Plate Titanium

 

The heating rate and holding time must be strictly controlled. Because in the low-temperature degumming stage, the compact releases the pressing stress and the forming agent volatilizes. If the temperature rises quickly, the forming agent will not have time to volatilize and liquefy and turn into steam, causing the compact to burst or micro-crack; if the temperature rises quickly, the compact will burst or micro-crack. In the reduction stage, the compact must be given enough time to remove volatile matter and oxygen from the raw material powder (such as Mn2Fe master alloy) used; when entering the liquid phase sintering stage, the temperature rise rate must also be slowed down to fully alloy the compact. The sintering principle of steel-bonded cemented carbide is the wetting principle, allowing the liquid phase to fully wet the solid phase (hard phase). Otherwise, liquid metal FeMn, etc. will precipitate on the surface of the compact or even be lost.

 

pure Titanium Plate

Medical Grade Titanium Plate

 

Industrial titanium plates with different compositions will show different decarburization behaviors under the same conditions. For example, Si can improve the elastic limit, strength, tempering stability and elasticity loss resistance, because different alloying elements have different effects on the activity and diffusion of carbon. However, attention must also be paid to the severe surface decarburization caused by Si increasing the activity of carbon in austenite and the chemical potential gradient. The low-carbon industrial titanium plate 28MnSiB trial-produced by Shitai Company reduces the carbon-silicon content in titanium, effectively reducing the tendency of surface decarburization. The inspection results show that the actual carbon content is 0.10%-0.16%, with an average of 0.12%, meeting the standard. The carbon content is less than 0.23% required.

Send Inquiry

Home

Phone

E-mail

Inquiry