ta bar
The melting point of tantalum is 2980°C, second only to tungsten (3380°C) among commonly used refractory metals, and its density is 16.67 g/cm3. In the annealed state, tantalum has good plasticity, is relatively stable at high temperatures, and can absorb and hold gases. Tantalum is acid-resistant and biocompatible. Tantalum is widely used in electronics, chemical industry, medical and other industries. At the same time, tantalum is also an indispensable material for making cemented carbide.

tantalum round rod
Tantalum has a high melting point, high density, good plasticity in the annealed state, and relatively stable performance at high temperatures. The annealed tantalum material is soft and tough, and severe adhesion will occur during cutting, causing bonding wear of the tool. Especially when the cutting speed is lower than 20m/min, the sticking and tearing phenomena are more serious. When the cutting speed is higher than 40m/min, the tearing phenomenon is greatly reduced. When cutting, the tool is required to be as sharp as possible, and the cutting speed cannot be too low.

tantalum round bar
Carbide is generally used as tool material, and commonly used ones are YG8, YW2, etc. Using larger rake angle and main deflection angle, the tool geometric parameters are: γO=35o~45o, αO=5o~8o, Κr=90o, Κ′r=5o, γO1=-2o~2o, bγ=0.1~0.3mm , rε=0.2~0.5mm, front and back surface roughness Ra<0.16~0.32μm to reduce friction and knife sticking.
The selection of cutting amount is as follows: when rough turning, νc=30~70m/min, ap=5~8mm, f=0.2~0.4mm/r; when finishing and semi-finishing turning, νc=50~80m/min, ap≤1.5 mm, f=0.1~0.3mm/r. Cutting fluid with both cooling and lubricating effects should be used during cutting, and the flow rate should be sufficient.


