Feb 20, 2024 Leave a message

Descaling And Pickling Of Titanium Rods And Titanium Alloys

ti alloy rod
 

 

The pickling conditions of titanium rods and their alloys are determined by the type (characteristics) of the oxide layer and the existing reaction layer, and the type of this layer is affected by the high-temperature heating process and the increase in processing temperature (for example, forging, casting, welding, etc.) Influence. Only a thin oxide layer is formed at a lower processing temperature or a high heating temperature of about 600X or below.

 

round bar ti

titanium alloy rod

 

Under high temperature conditions, an oxygen-rich diffusion zone is formed near a certain oxide layer, which must also be eluted by acid. In addition to this oxygen-rich diffusion layer. Various descaling methods can be used: mechanical methods to remove thick oxide layers and hard surface layers, descaling in molten salt baths and pickling in acid solutions to remove scale.

 

round bar titanium

ti metal rod

 

In many cases, a combination of several methods can be used, for example, mechanical removal of scale followed by pickling, or salt bathing followed by pickling. In the case of oxide layers and diffusion layers formed at higher temperatures, special methods must be used. However, most of the oxide layers formed when heated to 600X can be dissolved through general pickling.

Send Inquiry

Home

Phone

E-mail

Inquiry