Mar 07, 2024 Leave a message

Ferrosilicon: Why Should The Material Surface Be Kept At A Certain Height?

The height of the material surface is too high, the contact area between the electrode and the charge increases, and the passing current increases. In order to maintain the rated current, the electrode needs to be raised. Therefore, the depth of the electrode inserted into the charge becomes shallower, the high temperature zone moves upward, the crucible shrinks, and the heat The loss increases and the chemical reaction speed slows down; the temperature of the furnace bottom is low and the slag discharge is not good, which may even cause the furnace bottom to rise and worsen the furnace condition.

 

high carbon silicon alloy

ferro silicon alloy manufacture

 


If the height of the material surface is too high, the silica in the charge will roll to the bottom edge of the cone, and its adverse effects will be more serious.
If the material level is too low, the electrode will be inserted deeper into the furnace material. However, due to the thin material layer, it is easy to loosen the material and even cause arcing. The material layer is thin, the charge cannot be fully preheated, and the heat loss is large, which is not conducive to expanding the crucible area.

 

Si65C15

ultra-low carbon ferrosilicon manufacture


Practice shows that the flat-top shaped material surface is more suitable. Because the material surface has a suitable height and the cone is wide and gentle, the added charge still maintains the correct combination and the distribution is uniform, and the phenomenon of silica rolling down rarely occurs. Therefore, the electrode can be inserted into the furnace charge relatively deeply and stably, which is conducive to increasing the furnace temperature and expanding the crucible. The chemical reaction in the furnace can be fully carried out. The material surface has good air permeability and the furnace charge is well preheated, so the furnace condition is normal.

Send Inquiry

Home

Phone

E-mail

Inquiry