Feb 18, 2024 Leave a message

Reference Standards And Technical Requirements For Industrial TA3 Titanium Rods

ti alloy round rod
 

 

Reference standard 1: GB228 Metal tensile test method.
2: GB/T3620.1 Titanium and titanium alloy numbers and chemical compositions.
3: GB/T3620.2 Chemical composition and composition tolerance of titanium and titanium alloy processing products. 4: GB4698 Titanium sponge, chemical analysis methods of titanium and titanium alloys.

 

solid ti bar

titanium round rod stock

 

skills requirement
1: The chemical composition of titanium and titanium alloy rods should comply with the regulations of GB/T3620. When repeated testing is required, the allowable deviation of the chemical composition should comply with the regulations of GB/T3620.2.
2: The diameter or side length of hot-processed rods and their allowable deviations should comply with the provisions of Table 1.
3: After hot processing, the bar is turned (ground) and cold rolled. The allowable diameter deviation of the cold drawn bar should comply with the provisions of Table 2.

 

 

solid ti rod

ti round rod stock


4: The out-of-roundness of the turned (ground) bar after thermal processing should not be greater than half of its dimensional tolerance. 5: The variable length of the processed bar is 300-6000mm, and the variable length of the annealed bar is 300-2000mm. The fixed length or double length should be within the range of the indefinite length. The allowable deviation of the fixed length is +20mm ;The double length should also be included in the cut amount of the bar, and the amount of each cut is 5mm. The fixed length or double length should be included in the contract.
​

Send Inquiry

Home

Phone

E-mail

Inquiry