Mar 07, 2024 Leave a message

Solution To Ferrosilicon Powdering Phenomenon

The cooling rate after casting also affects the powdering of ferrosilicon. The cooling speed of ferrosilicon is fast and the segregation degree of silicon is small, so it is difficult to pulverize; the cooling speed is slow and the segregation degree of silicon is large, pulverization is easy to occur. By the same token, thicker ferrosilicon ingots are prone to pulverization, while thinner ones are less likely to pulverize.

 

ferrosilicon 75

Ferro Alloy Supplier

 


In order to prevent ferrosilicon powdering, the following three points should be noted:
1. The thickness of the ferrosilicon ingot should not be too thick to reduce the degree of segregation of the silicon content in the ferrosilicon.

 

ferrosilicon powder

Ferro Silicon factory


2. Strictly control the silicon content of ferrosilicon, not too low. Control the aluminum, phosphorus and calcium content of ferrosilicon. For this purpose, better raw materials must be used, especially high-ash coke cannot be used to reduce the aluminum and phosphorus content. In order to reduce the calcium content of ferrosilicon, the addition of lime should be minimized during smelting.

Send Inquiry

Home

Phone

E-mail

Inquiry