The properties of gas coke and metallurgical coke are compared as follows:
1.Resistance
The resistance of gas coke is greater than that of metallurgical coke. Even at higher temperatures, its resistance is still greater than that of metallurgical coke. The important advantage of gas coke is when the resistance is high. Practice has proved that when smelting ferrosilicon, part of the gas coke is used, and the electrode can be inserted deeper into the charge, thereby reducing power consumption.

fe silicon
2.Chemical composition
Gas coke contains lower fixed carbon and higher ash content, and is not as good as metallurgical coke in terms of chemical properties. This is caused by the low coking temperature of gas coke. The carbon content of gas coke is low, and more should be added when using it as a reducing agent. At the same time, due to the high ash content in gas coke, the amount of slag during smelting also increases. On the other hand, due to the low carbon content in gas coke and its Mechanical strength is poor. During smelting, there is often a lack of carbon in and below the crucible. It can be seen that gas coke is used as the reducing agent in ferrosilicon smelting, and the furnace condition is difficult to maintain.
3. Porosity and reaction ability
The porosity of gas coke is 40-60% greater than that of metallurgical coke. This not only increases the resistance of gas coke, but also expands the reaction contact area. On the other hand, the reaction capacity of gas coke is also higher, which is beneficial to speeding up the reaction speed. conduct.

Ferro Silicon Supplier
4. Cost
The price of gas coke is 10-20% lower than that of metallurgical coke.
The above-mentioned gas coke has the advantages of high porosity, high resistance and low cost, but it also has the disadvantages of low carbon content, high ash content and poor mechanical strength. Therefore, it is not advisable to use all gas coke during smelting. It can be used in conjunction with metallurgical coke. Practical experience has proven that when used together with 30% to 40% of gas coke and metallurgical coke, the effect is better and the unit power consumption is reduced.


